raptor clutch in banshee

[clayton00grand]

ok a while back I installed a raptor clutch fibers in my shee, when my much older shee fibers shatter 2 or 3 of them. Anyway after riding for a while I notice fade and its usually really bad I only installed fibers and 3 of the 6 HD springs along with my stock springs that i took out. But what I noticed is the raptor kit has 2 fibers that has a larger inner diameter I'm assuming for a cushion install or something. Because there was 8 plates which is obviously too too much for the install. So if someone could lend a hand I would appreciate it. I'm just afraid that the fiber are the problem being that one is different diamter.

[LS1Inferno]

why not just get a good banshee clutch kit?

[clayton00grand]

Its not that I didn't want to put a good kit in I had it handy to keep up and running, is the fibers the issue??

 

 

Because it looks liekk the 2 fibers are set up for diameters with cushions obviously no cushions are installed. should i take clutch fibers out Thoughts please.

[bigboybanshee]

Were your steels in good shape? If you re-used them, you should have cleaned them good, checked for heat, and scuffed them up pretty good before re-installing them, given they weren't damaged.

 

Either way, I'd replace the fibers with the appropriate ones :thumbsup:

[shanYE west]

If your using the raptor clutch.. you need to get rid of them 2 smaller fibers and replace them with the bigger fibers. You should have all 7 fibers the same size. (the ones with the smaller ID) Dajogejr is running the raptor clutch in his 10mil cub and has had good luck so far with it.