GOFAST222

Does the rear swing include the front chain slide and rear guide?

Recieved the fox shocks today, well packaged and as described. Thank you.

Hey, I pm'd u about the fox shocks. interested.

interested, do u have to run these with a battery?

I bought the front a-arm's, tie rods, front bumper, and rear grab bar. I was led on to think the parts where going to be shipped out the next day, but didn't get shipped out til Saturday. It would have been nice to know the arms where old school arms with Honda taper ball joints. texted the seller and asked if he had the spindles to go with the arms. he said he was going to keep them for another build unless I bought the rest of the front suspension he had for sale. No biggy, I should have asked. I then bought a $80 reamer, then replaced the upper ball joints to 16mm stem since the ones in the arms where bent. the front bumper was missing spacers to bolt to the frame, no biggy again. Finally in the pic of the parts for sale I would have assumed the rear fender supports were being sold with the grab bar as there wasn't a listing for them, wrong again. I'm not mad, but feel a little let down on the sellers end.

Money just sent, thanks for a good deal.

Sent u a pm.

PM u on the trans, carbs, filters, and intakes.

Pm sent.

Text and asked if u would sell the motor complete, no reply.

Traveling to Michigan anytime soon?

PM YOU.

Im very interested Walz, and yes your cascade clamps will fit. I have Cpi inframes with Cascade clamps and Cascade silencers on one of my shees.

Sorry to the seller, I am not going to sit and argue on your post with differences of opinion. Shearer and cpi are both higher end pipes, well liked, both are a mid to top end pipes. I could see if I were compairing dg's or fmf's to the cpi, but I am not. In your eyes Sprinklerman I should be comparing the cpi's to what? LEDS? to me these are apples to apples. Done.

Please school me on the going rate of used parts. To me if something is used, its used. I have always went by the idea that around half price is a good starting point. give or take. I didn't mean to insult anyone by the offer and I was comparing apples to apples.

Shopped Ebay, Shearer's and Cpi's go for the same price 699.99.

set of shearers just went for $375 shipped from nitroburner. $375 I can pay asap. text me 269-547-1250.

Are these big bore or small bore?

$250 plus shipping?

Ill take the carbs, and billet kicker. paypal addy or text me 269-547-1250.

Front spindle mounts, name your price. payment ready as long as they are banshee taper.

Everyone pretty much summed it up. Sparkies, rectangle pennant orange flag. Just measure the overall height on the shee. The height bar is 10ft. But sags at the end away from there building. You will need to purchase a state park sticker for each motor vehicle that enters the park. On your quad u will need a orv sticker and a trail sticker. I live right in mears and go to the dunes every wkend. Last wkend was very busy, I did get in line for a parking voucher for Saturday. Sunday I was able to just drive up and get a voucher and Monday they where not handing them out for the parking lot. I figure this wkend I won't get up at 6am to go park a car in the line for parking vouchers that are handed out at 9pm. Hope this info helps.

I'm looking for a stock carb boot. If anyone will be up at Silver lake sand dunes this wkend and has one, Id like to buy one so I can run the new toy this wkend. thanks. shoot me a text 269-547-1250. thanks

Will you take $50 shipped?