special06shee

Full flight=junk Asr= ok

hell yeh it is. But your still hauling the mail

These use heims but are WAY better then full flight. You can actually contact asr and swap out the heims with their ball joints before initial purchase

http://bit.ly/1jMAyL2

If you want a decent cheaper arm, look into ASR. They offer nice ball joints with their arm and i believe they are only a couple bucks more them full flight.

+3+1 arms with a 4x1 front offset rim is kick ass setup

Correct. A leak down should be done before break in.

21cc should put you in the 140range. Personally, if the motor is all stock, and has a decent amount of hrs on it, i would not be real found of throwing more compression at it w/o truing and welding the crank up. I just dont see it being worth the added stress

Hell, id call mat up and talk to him. I have a hard time believing he wouldn't make you that pipe.

Do you have a manual 1st?? Bike looks pretty consistent.

Stock length are 14-1/2 or 14-3/4 eye to eye. (Forget) so im assuming they would drop ride height 2 to 2-3/4" depending on preload

Yes. Toomeys. The needles cleaned up my mid range considerably when i was running 4m sc bike

165m55p was what i was running my 10cub at

If i had another cylinder id buy them! Free bump for bad ass tire/wheel setup!!

Sweet tanks! What is the fuel capacity?

Air hammer with chisel bit.

Lol. Deadbeat is my hero!

Ddq make me laugh..

Seems a little steep for a roller. Specially if it is all stock suspension, arms, axle... A stock motor will run you anywhere from 600-1500. If you keep your eyes peeled on here, there are always smoking deals on super nice motors ranging from 1500-5500. In all honesty, if you pay 1500 for the roller, figure on another 2-20k (depending on parts you decide to go with) before you ride it. Its the little things that add up QUICK!

Im waiting going on 2months for my new small bore oofs. Maybe they are tied up at the chrome shop?

Im always superman when im at trevorton?

personally dont think it was mis info

Haha! No wonder. Very nice

The small bores on a 535 will hold too much heat

Wow thats a tire!! X2 on the pic of the bike!! I wish these were a smaller RO. GLWS!!