Finch

hammer? ive dont it on truck rims before just dont mess up the metal where the bead seals

How far are ya from sl?

haha if only you weren't a days drive away!

Also thinking im going to get the case port matched.

So im picking up a 68x54, and a 115 rod crank. Going to start putting it in when it shows up, but i had some questions and advice. Ive yet to split my cases what all do i need to get to replace crank, seals gaskets ect. (i figure on base gasket and clutch gasket). Am i just better off getting a complete set of seals and gasket sets? if so any brand suggestions? Also lock washers and clips and such? Its going to have 19cc domes(5000 ft elevation) until i check comp and see whats going to be the best application. New to cubs so any advice or input would be sweet! Im going to be ditching the t5s and stock carbs since i know that wont be the best. Probably going to go with some mid 30's mikunis and either cpi or shearers if i can get my hands on some. Ive already got a +6 and some 10pdl haulers i think will work decent. Just looking for some more info cant seem to find much info on baby cubs. Thanks

good idea never thought of that id be worried about covering both ends some of that drain cleaner ya add water to expands quite a bit might shoot a cork flying but never know better safe then sorry

link no work for me? says expired

id say worth a shot

0000 steel wool and elbow grease. sos pad works good but sometimes puit light scratches in the chrome but hard to see at a distance

Some stuff added sold parts taken off!

why thank you sir

Well good luck on the sale! read the rules and restrictions and tips and you prolly wouldn't of gotten hazed.

i put some cuts on rode the trails for a bit and put my uncuts back on didnt like the mud and shit hitting me i got some white cut ones for sale if ya wanna try some before ya commit

serval has more low end then cub. cub pretty much no low end

i think most of it is for higher comp and timing i havnt ever seen a cub on pump but its possible

sell it on ebay

non oring chain FTW! finger muscle needle nose my help but not sure!

not sure of the older ones but im sure they do!

If they don't sand it off and put it on thin you can otherwise ur sol

ya id say just restamp it back in thats what they do here or just hope ya never get pulled over by a dick cop that wants to check to see if it matches your registration

did ya look on the bottom of the frame? i know here if ya need a vin ya just take it in and they stamp one on it or give ya a decal with it

Trips back to the truck with out any drawers isnt to bad.

KoC templates FTW!

I have the nomad pants and they melted to my pipes after first day of riding