Joejr915

Has anyone ever blocked the little hise that comes out of head

Im looking for a set of 5/8 spindle mount wheels with brake setup

Im looking for a set of spindle that are use on rigid chassis? Or know where to buy them or how to make them.

What is the best clutch pusher to buy. Have one now that seems to be short its a chariot. Or does anyonr know any brands that have interchangeable rods

Im looking for a 4 mil topend. Need cylinder and head with domes and pistons is so. I perfer a cub. Need drag ported if so thanks

About how much hp can u get out of a 10 mil cub - cheetah - dm or a 4 mil dm . Looking for hp numbers on gas. Curious on my nee motot i want to build this winter.

When i pull in the clutch lever all the way in it wants to drag. I have it adjusted correctly idk whats up. I have dd lock up on it with 3 stock springs and 3 hd springs.

Thanks

Looking for some straight cuts. 2.68 ratio used

I have 535 cheetah with 39 pwks and oof shearers. Its drag ported. I need help in jetting i dont know what needles to put in it or what jets? My elevation is 1500ft above sea level.

I have a 543 cheetah and i was wondering what kind of setup should i use with it. I drag race 500ft. I have 6 driveline hd springs in it with dd lockup with 6 bolts on the lockup 3 of them have double lock nuts. I need help tuning this setup.

I have 39pwks on it and i want to run q16 thourgh it what needles and jets to u recommend. I mix 32:1 with amoil

Great seller and fast shipping thanks for the nice pipes

Pm sent

Working with a 543 cheetah. Just put together my new motor and fired it up. When i rev it up it sounds like something is holding it back or like something is tight. It has 39 pwks with 52p and 175m. Timing is 90 thousands with a pvl. Squish is 56 thous. I pushed the kicker down with my hand its not bad about the same as my 4 mil. It sounds fine when its idleing. Cannt figure it out. Any info will be helpful. Thanks

thanks i didnt know whereto start

i need help jetting my motor 535 cheetah motor. main, pilot, air screw setting and what needle. my elevation is about 1500ft. im will drag racing on dirt.

im looking for a set upp 35mm intakes for a banshee?

looking for a seet of 39mm intakes for a cheetah cylinder? perfer upp

im looking for a 1-5 override?

cool thanks i wasnt sure what to do i probably would go with vforce reeds then

Cheetah not cub people told me to put in stock but I wasn't sure why

Would u recommend stcok cages with boyesen reeds or vf2 for drag racing I'm building a 10mil cheetah

I'm looking for some parts for my cousin. He needs pv powervalve block offs, intakes for 39mm carbs, domes his bore is 73 or 73.5 not sure, and the fittings for head. And also mayb for one used pistonto check the porting on the cylinder. It takes the cr250reeds

i also race at this track and seen Brad helps people out at the track. if u need something for a banshee ask him and he probably has one and would let u use it for the night. brad a good friend. i have seen zach bike. Zachs bike ran pretty good with the snipers he was running consistent 6.3s. but i know is it was getting faster as the season went but i dont was brad was doin to it. i know zach like the pipe cuz i asked him when he first got them he said it ran better then ever. but i cant tell u if someone touched up the porting but all i can say it something happen to it because it got faster late in the season.