Modified RC

I got them from here http://www.harrisonspecialties.com/mm5/merchant.mvc?Screen=PROD&Store_Code=HS&Product_Code=GreenLEDwithwires&Category_Code=Green I also got the billet tail lights from them and they are very nice too. You can get the replacement bulbs in a few different colors.

They look great. Here are my green lights

The crank bearings, and also the rod bearings should be replaced if they have any up and down play at all.

When you get the engine apart check the crank bearings real good, make sure all the little rivets that hold the bearing cages together are all still in place. Also check to make sure a reed screw didn't come loose and get in the crank area. It could be many things that got in the engine but I would check the two listed above first.

Here is my Clarke 5.5 gallon tank

+1 to that advice Using 2 pieces of solder will get the closest reading because the piston can not rock to one side, all bearings have a little play in them so use 2 pieces of solder to eliminate the play in the wrist pin bearings to get the closest reading.

I set my 485 ring gap to .012-.014, that was suggested by my porter.

I always liked the bright green.

Nice work! I did the same thing with the sink strainer and I got past the gate and in the dunes with no problems.

Where did you get the block-off plates from?

Thanks for the info! Maybe I'll see you out there this year and do some duning.

Last year I was running the Trinity pipes and silencers and the silencers didn't come with spark arresters. I made these housings to hold screens and I got in the dunes with no problems. I got the screens at a hardware store, they are used in sinks(plumbing department)

Not sure about the sound check, but if you don't have spark arresters they don't let you in the dunes. Every quad gets checked for spark arresters at the enterance gate for the dunes.

Did they still let you ride the dunes? What did they say? I haven't been sound checked yet but I don't want to be either.

Nice work on those, they look great and don't stick out too far. I need to make a longer grab bar for mine because the sparky's added alot of length.