shovelhead

Well guys I need your help again. I finally got my shee back together a little while ago & I was excited to start her up..but NO it didn't happen..Damn OK I put on a Toomey T5 kit, I did each carb jetting seperately to aviod any mix up everything went smooth, Then I put them back on & Yes I kept those damn Tors.. I then proceeded to install the new T5's. No problems, I also did a Ign Swap with a new Dyna mod. Plug & play deal No problems..Air box Mod done .Everything hooked back up Gas turned on , gas was flowing to both carbs..NO Start!! I removed the Dyna, re-installed the stock one ..still NO! Put Dyna back on & Now I am lost. This is a New 06 Banshee 2 months old. I have some knowledge to perform mechanical , but I am lost when it comes to electrical? Could it be something in that Tors system? ( Yes I plugged it back in) It was cold out in garage, so this all I did so far ..I knew maybe someone here could help me figure it out better than guessing.. It really sucks. I have been waiting for this day like 2 months.. I guess someday I will get to ride it.. any help or suggestions of things to look for greatly appreciated. P.S. Keep in mind that I only have had this Banshee 2 months, and ridden it like twice . I start it by turning on key, push button to start pos., Choke on & kick.. Is this correct?

I took off stock pipes, & put Toomey's This would make since ...No spring needed for new pipes? I thought I was loosing my mind..

Guys I must be a Dumb @ss. I took the exhaust , Carbs, & fenders off 3 weeks ago, and just got time to get around to re-installing everything today ..I ended up with a Spring left over? I remember taking it off, but where from?? It is long spring apprx 10"-12" long. I thought I laid everything out together( I had them with my 4 exh. springs? ) can someone help an old man? If needed I can get a pic of it..

Do you still use a chassis ground ? or ground to switch? Thanks

Well last week I installed my tethered kill switch, and This week my Dyna Ign. Mod came in . There is this bright Yellow warning label in box that states: Do NoT Use A Kill switch That is Grounded & uses coil for hot wire?? Now what? I used the Coil & chassis ground? Where is the next best place to wire up the kill swithch?? Any Help greatly appreciated....

Thanks guys! I appreciate the info.

I am getting ready to install a kill switch, and I was going to use the wiring from the ignition switch. Is all I need to do is to connect the hot wire to red & black in the switch ( Key) & the black to black ground? or is there an easy , simplier way? Thanks & Happy New Year Everyone

I cannot shake the cable keeper loose , so how is best way to remove it without screwing something up? Thanks in advance

I got a DG 28 PWK carb kit ready to be installed, I need to know something about this cable junction box?? Where should it be mounted to work properly? or will it work anywhere? I never used one before.. Thanks

Not well enough ....

On 2006 Banshee, If I rip out all the tors wiring & box. Do I have to do anything else to wiring ? I have read so much crap on Tors that I confused myself.. I Just want to get rid of it, and get my new carbs on & ride! Thanks in advance for any help. Yes I did a search.. Thanks guys!