xXBlessedWithDeathXx

I`m looking for durablue eliminator axle hardware. i need everything but the axle and axle lock nut. i wrote durablue and they sent me a list of what i need. it totals out at $74 without shipping. i`ll trade the my plastic for it. new or used or better offers but i`m in need of them parts and funds are getting low. i still have a little i have to trim and sand but they will be done before shipped.

Dont jump :beer:

nope lol. same slug new frame and exc...

its hard to believe there not sold lol.

My shee is tore down.

yep, i have a set and love them. i`ll never go smaller then 34mm and i have no porting.

and it will always be the best quad ever built. :thumbsup:

your friends a idiot. :biggrin:

i dont jump and if i was to get air it wouldnt be much. for the price of them axles i would think they are good.

thanks guys. i wasnt sure about that clip.

I have pics below.

About a month 1/2 ago i picked up a durablue eliminator axle for $40. its missing all hardware except the locking nut. it will soon be time that i start my quest for parts but my question is. on the axle nut that locks the axle to the carrier it has a inner threaded sleeve that slides on the axle and a outer nut that screws on to the sleeve. the question is , is that when its screwed on it still slides off. am i missing something? i dont get it. i dont understand the concept of this damn locknut. i can get pics if needed.

welcome and we are all jealous that you can ride the streets legally. :beer:

do a disk cleanup and delete cookies. i run the original ad-aware SE that stoped doing updates for over a year now and use Nortons. i never have problems. i also use pcpitstop optimizer.

I have a set of triple rate w/rez and i cant believe i kept the oem shocks as long as i have. works makes the ride so much better. you dont get beat up nearly as much witch makes riding more fun. if i were you i would do it. just make sure they are for +2 if thats what you plan on getting.

this is a good running motor. i seen lucy climb them hills at coalhill. i`m sure i have vids in the video section.

nice hahaha.

I`m sure i can find one on Obama but i dont have the time lol.

you used that?

if it helps you can go to a hardware store and get washers that will work for spacers. specs are .610" ID x 1"OD. if you can find a thick washer to fit it should be aprox .275" wide. or you can take them dimensions and get some made. i found them specs on a old post.

J arm is 87 threw 89 and possibly 90. i have a 87 and had one hell of a time getting that bolt out. i had to cut it out and buy a new one. the bolt was froze fast to the inner sleeve. if your lucky you wont have that problem. good luck.

Balljoints on ebay for $25 a shot. i also have a set of them arms. i believe that are 89 warrior ball joints. they screw in (NOT PRESSED) very nice arms.

NGK spark plug resistor cover LB05F stock# 8051

what was sold?

i`m sure you`ll get it.