crazybluerider

package deal for shocks and arms shipped to 97211? Are the front shock setup for the a arms?

Shocks set up for those arms? What about the rear? has it been revalved or anything? Package deal price for shocks and arms shipped to 97211?

Do they both have rotor mounts still? How much shipped to 97211?

Do you still have these?

If it is a 2 wheel drive truck with the 2 piece drive shaft it could be missaligned. Some of these drive shafts were not aligned properly from the factory due to a cross member being missaligned. Bel-tec makes a kit to repair this. It fairly cheap. I dont know exactly how much the kit cost because the suspension kit I ordered from them came with one.

Heat gun or a propane torch. Ive had better results with the heat gun as you have a little more control.

Here in portland they were trying to pass a law so they would have to get tabs for thier bikes. You shoulda heard the uproar. I think they use the road they should have to pay for it. Cars all have plates bikes should too.

DMC maeks one i think it is the 916 model.

I built my +3 for my 450 out of round .095 1 5/8" chromoly and it has held up very well. It is 1/2lbs heavier than the stock aluminum swinger. It was 12lbs for the swinger and carrier. I building a plus 4 for my banshee right now out of the same stuff should be a lot lighter than the stock banshee swingarm.

I could be wrong but I think its for the choke. Its on the carb with the choke handle.

I just saw that you were in Australia. I go the K&N part number off the box for ya and the outerwear# maybe you can source them locally. K&N# RU-1060 OW# 10-1066-02