nigels_world

Epic thread...

Actually I was at 4700 feet. I was at 310-25 on the jetting there.

Shakar - I live in Franklin, right next to Ellsworth. How about you? I grew up here so the cold is familiar. Savage420 - that's always a good read.

I just moved from high elevation in hot Arizona to sea level in cold Maine so I'm obviously going to be way lean. I have no idea where to start but am totally confident that I can tune it once I have a starting point. Like I said I'm at sea level (I live right on the ocean) and the temps have been 15-35 degrees f. Specs for the banshee are: ported jugs (I have no information about them) v force 3 reeds rz350 carbs fmf pipes k&n pods (no box) stock timing where do I start?

Rule of thumb is that over 150 psi you will need more than pump gas.

Move out here to AZ...

What's your elevation?

When you buy a filter I would strongly recommend something OTHER THAN the stock setup.

:beer:

I use Yamalube 2R as well...

What part of Maine?

I grew up in the Ellsworth/Bar Harbor area... Then I came to my senses and moved to Arizona. :tongue:

So if I go with the 19s and decide to venture out to Glamis it would just require burning race fuel for the weekend (and obvious rejet) correct?

You think 19s would be too much?

Agreed thats thinner, not stripper. Aircraft stripper is what you want.