FOXBANSHEE30

I'm about to tear my banshee down now that i got teh motor right. Since its has hydros whats the best way to get the a-arms and stuff off?? Am i gonna hve to bleed the whole system then set it back up later. How hard would that be?? Thanks for the help. MEADOWS.

How do i advance the timing? That sounds like a pain in the ass, Thanks for the help. MEADOWS.

so what size should i run? As far as i know the timing is stock. And yes porting does lower your compression. What size?? Thanks for the help. MEADOWS.

Where exactly does this thing install?? Thanks for the help. MEADOWS.

I live in middle TN. Im not sure of my elevation. Can any of u guys tell me? Thanks for the help. MEADOWS.

Hey i got a 97 Banshee with a few parts and a mild P&P, and im about to get a NOSS HEAD but im not sure what size domes i need to run. I want to boost the power some but i want it to be safe for the engine and i still want to use pump gas. What size would be good? Thanks for the help. MEADOWS.

Hey i was wondering if these Pro Design EZ Drain things are worth the money and are they hard to install?? Thanks for the help. MEADOWS.

Hi, I have the 2 into 1 with the 33mm Keihn carb w/ the K&N Clamp on and i absolutely love it. It is a lot easier to tune in my opinion. It's a bit pricey though but i think its worth it. Thats my 2 cents. MEADOWS.

Hey does anyone know a good custom truck site?? Or anything about air suspension for a truck?? Thanks. MEADOWS.

Alright now that i found the problem i need to fix it. I broke the needle on my carb and my local parts shop says they cant get keihn carb parts, but they will sell me a new one.... yeah..i bet they will.... anyway so heres the question... Where can i get just the needle for my PWK?? Thanks for the help. MEADOWS

i broke a the needle cuz im just that bada$$! no im jokin i have no idea how i broke it. Well the needle doesent have any numbers or letters on it. So what do i do now? I could use the help. Thanks. MEADOWS.

thanks guys. i got the problem my needle was broke. MEADOWS

gigidy-gigidy all right!! I found the freakin problem!! My needle was broken thats why i couldnt dial it in. So now i need a new needle. Do i need a specific size?? Or taper or anything?? Thanks in advance for the help.

i have a major problem that i cant figure out. My banshee wont idle, it loads up on the bottom end, runs good 2nd through 3rd, in 4th it will run right unless i open it wide open and it seems to almost quit but if i let off and just gradually accelerate it runs good, but if i good wide open is falls off with no revving and no power. I have changed the main and the pilot jets and still cant find the problem. i have fiddled wih the idle screw and the air screw and cant get it right. The only thing i havent messid with is the needle. I have a Trinity Stage II 2 into 1 carb kit w/ a keihn PWK (not sure what size). Can anyone help me?? I need it bad.

i have a stage II trinity 2 into 1 carb kit with a keihn PWK on it and i cant seem to get the needle out of the slide. Is there a certain way to get it out? Thanks. MEADOWS

Hey everyone my names justin and im new to the Banshee world. Sorry if this is a stupid question.... Does it matter which plug wire is on which plug?