Bel Ray MC1 Question

[TRO73]

I recently rebuilt my bike..basically everything in my sig...Had it running pretty good and I switched to Bel Ray MC1 50:1 with 110 octane just to be safe. Well went riding today and I had a slight bog again in my bottom end. I know the bottle says leaner jetting may be required. Has anyone else had this when they switched? I am running 155 main....45 pilot... needle 4th clip down...2 turn out. It doesn't do it all the time, I did alittle draggin and in 1st and 2nd they got me because my bike would not go very well. Checked my plugs all day and they looked good. My elevation is around 800 where I ride.

[locogato11283]

im not familiar with that oil.. im not so sure i would trust something that says, "leaner jetting may be required."

 

maybe you should switch to klotz..

[TRO73]

Well I got about 10 gallons of race fuel left @$6.69 a gallon so I would like to use that up first. I was at St. Joe park today "seen where you were from" where do you buy Klotz at?

Edited August 24, 2008 by TRO73

[locogato11283]

Well I got about 10 gallons of race fuel left @$6.69 a gallon so I would like to use that up first. I was at St. Joe park today "seen where you were from" where do you buy Klotz at?

i dont live anywhere near st. joe state park.. thats over on the east side of missouri, im on the west side..

 

 

you can buy klotz anywhere.. most yamaha dealerships even have it. otherwise, call FAST at 785-364-5325..

[TRO73]

OH Thanks Man.

[jharader]

I run mc-1 in ALL of my 2strokes (even the weedeater)... pricey but a VERY consistant good oil, klotz is good shit to... i run it 40:1 though. got a clean filter? id lean more towards your airscrews if theres a bog at bottom.