sheeblue01 Posted May 7, 2008 Report Posted May 7, 2008 I just had my engine built by Jim at Passion, It should be here tomorrow. What I am wondering is, I won't be able to buy a set of pipes for a few weeks, can i run my built motor on the stock pipes for now? I will be running stock carbs too. If anyone can give me an idea on etting that would be great. I am in Indiana and 700 ft asl. Flame away.. Quote
Black&Red87 Posted May 7, 2008 Report Posted May 7, 2008 Depends on your motor work but you still would be hindering your performance drastically. IMO Quote
sheeblue01 Posted May 7, 2008 Author Report Posted May 7, 2008 Depends on your motor work but you still would be hindering your performance drastically. IMO The engine is ported and it is a low-mid focus on the porting. Other then that the head has been shaved a little, right around 165psi. I understand that my performance will be hindered alot. I just want to make sure that it doesnt lean out and fuck anything up. Quote
Black&Red87 Posted May 7, 2008 Report Posted May 7, 2008 The engine is ported and it is a low-mid focus on the porting. Other then that the head has been shaved a little, right around 165psi. I understand that my performance will be hindered alot. I just want to make sure that it doesnt lean out and fuck anything up. Just get your jetting right, Jim should be able to give you the best info though. Quote
sheefreak Posted May 7, 2008 Report Posted May 7, 2008 I have a feeling Jim will say, stock pipes, what are those??? It won't hurt anything to run it, just start out fat on the mains and go down from there. Quote
Animalman294 Posted May 8, 2008 Report Posted May 8, 2008 Ya, it'll run alright, once jetted, just nowhere near its potential..... Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.