Out-of-Frame Install?

[Colby]

What all is involved in an out-of-frame pipe installation on a banshee? Building a drag 4 mil, goin with shearer small bore oof. Do all the neccessary peices come with the pipes? How do they mount? Tried search but to no avail. Thanks in advance.

[dajogejr]

Luck of the draw...my man.

The pipes will come with everything except pipe springs and a mount for the peg. On mine, I use a stock front pipe hanger to mount them. In my opinion, it is CRITICAL they are not solid mounted, they need to have rubber/bushings to flex or give.

 

Normally the mount bracket on the lower pipe will not line up properly with the peg, you'll have to get creative.

I also bought small isolaters to mount the pipes to each other to make things easier (think of a rubber block with a stud out each side)

 

I will send you a pic of mine later today if I can remember, I have to put mine back on tonight....

[trex banshee]

Mine fit like a damn glove! :biggrin: All the holes lines right up, i do however have to get some type of rubber in between the mount and peg though before i do much more riding.

[dajogejr]

Check out Grainger...they make nice isolators.

Also...a log of cold air intake kits have isolators in them when they remove the airbox. Just a thought.

[jbooker82]

Dont know anyting about fitting OOF pipes but you could go to the hardware store and buy a couple of rubber stopper and just use a bolt and a couple of fender washers.