cpi inframe ?

[Guest utleybanshee]

i have cpi pipes on my banshee were the header meets the mufflers right behind the carbs mine are about 2inches from each other and i have to use couplers to mate them are they supposed to be like that... where as is my procircuits overlap each other where they meet thanks...

[dekker]

The expasion chamber pipe should slide inside the stinger pipe. try shifting the expansion chamber around some and see if you can get it on there. Mine fit with no problems.

Zach

[njbanshee]

Sounds like your not mounting them right. I had them and they fit with no problems.

[Animalman294]

I checked my bike a while back and found out that the brilliant individual that had the bike before me switched the stinger pipe from one muffler to the other, which made it fit funny. Make sure the right is on the right and the left is on the left. There should be a stamped L or R on the outside of the pipe facing the frame...............

[Male Supremacy]

My CPI's don't fit perfectly (they're about 1/4" from mounting perfectly, but I haven't ran them yet), but 2 inches away from header to stinger? Something's not right. Try loosening all the bolts without pulling them all the way out (including the shock mount's in the front). See if you can arrange it that way. If not, pull the bolts all the way out, put the exhaust together, then try moving the shock mounts around till you get the holes lined up.

[Guest utleybanshee]

k thanks guys ill post pics of it later.

[Male Supremacy]

k thanks guys ill post pics of it later.

 

 

Any luck yet?

[Guest utleybanshee]

well on my j arm frame they mount and were about an inch from each other on my 99 frame that fit but they barely overlap each other..