myecrip Posted February 6, 2008 Report Posted February 6, 2008 i am going to be powder coating my frame and i need to take out my steering stem bearing and rubber piece does anyone have an easy way of doing this. thought i would ask before i dug into it dave Quote
wacko2000 Posted February 6, 2008 Report Posted February 6, 2008 Do you have a cylmer..(banshee manual) they tell you how to remove it.. There is a tool I believe also a trick, you would have to do a search for it but you have to buy a bolt and to nuts at turn it out.... Do a search for the size bolt you will need.. Quote
shanYE west Posted February 6, 2008 Report Posted February 6, 2008 I used a screw driver and a hammer to get the retainer out.. after that I used a bearing driver to push out the bearing and seal... Socket would work too. Quote
WinchedWolvy Posted February 7, 2008 Report Posted February 7, 2008 (edited) i am going to be powder coating my frame and i need to take out my steering stem bearing and rubber piece does anyone have an easy way of doing this. thought i would ask before i dug into it dave Go to autozone and get 2 30mm axle nuts and weld them together conicle to conicle then use a 30mm socket,works like a champ Edited February 7, 2008 by WinchedWolvy Quote
Snopczynski Posted February 7, 2008 Report Posted February 7, 2008 You just need a large head bolt that fits the internal nut in the frame, then thread a nut onto the bolt and tighten the two together. Stick a wrench on the bolt and nut assembly while in the frame internal nut, and loosen. Quote
NYUK Posted February 7, 2008 Report Posted February 7, 2008 cotton eyed joe sells a tool. it works like a charm. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.