Jayy Posted October 9, 2007 Report Posted October 9, 2007 Hello, everyone. I have installed my Lonestar -1 swinger and now my stock brake line is way too long. I have searched around and so far the shortest streamline or similar SS rear brake line I have seen is for stock length swingarms. Anyone have any ideas? Quote
chevy7398 Posted October 9, 2007 Report Posted October 9, 2007 i got the same problem, my -1 lonestar moved my caliper from the back to the top off the rotor and my ss line is about a mile to long also. i havent looked into getting a shorter on but if you find one post it up for everyone will ya Quote
jayzx10r Posted October 10, 2007 Report Posted October 10, 2007 (edited) i got the same problem, my -1 lonestar moved my caliper from the back to the top off the rotor and my ss line is about a mile to long also. i havent looked into getting a shorter on but if you find one post it up for everyone will ya I picked up an inexpensive line at Earl's supply, cut it to length, then put my own screw on hose end. They sell these at Earl's Supply or most speed/motorcycle performance shops. You just wrap the hose with tape, cut it to length, (I used a high speed cutting wheel grinder) slide the nut over the braided line, peel back and flare a bit of the s/s cover, insert the ferrel, slide the crimping barrel over the exposed teflon tube, insert the hose end into the hose, and tighten the nut. Viola!! An Easy Fix. I think it was $5.00 for the end...I picked the donor hose from their pile of miscut lines that had 1 good end for $5.00 too!! I got my $10.00 line :cool: http://www.holley.com/600743ERL.asp Edited October 10, 2007 by jayzx750 Quote
jayzx10r Posted October 10, 2007 Report Posted October 10, 2007 Make that Earl's Performance Products. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.