stevo3176 Posted September 30, 2007 Report Share Posted September 30, 2007 I just took the tors off my banshee and i replaced the caps with aftermarket ones. The ones I got came be adjusted with a screw on the caps which pulls the slides up and down. Can I use this to keep the bashee idleing or do I have to get the idle kit. The ways I have it now it idles fine but I am wondering if I will have problems in the future. Quote Link to comment Share on other sites More sharing options...
stevo3176 Posted September 30, 2007 Author Report Share Posted September 30, 2007 And what is roost over by my avatar? <---------- Quote Link to comment Share on other sites More sharing options...
theshee Posted September 30, 2007 Report Share Posted September 30, 2007 So you didnt get the drill and tap with the TORS kit you got? The roost you were asking about are points you get in the casino. :thumbsup: Quote Link to comment Share on other sites More sharing options...
stevo3176 Posted September 30, 2007 Author Report Share Posted September 30, 2007 No the kit just came with the caps. I do have a vito idle kit but it does nothave any instructions. Plus is works good now I don't want to fiddle around uless I have too. i was just wondering if anyone else opted not to use an idle kits and just used the adjustments on the caps. Quote Link to comment Share on other sites More sharing options...
Bansh-eman Posted September 30, 2007 Report Share Posted September 30, 2007 you want to set your idle off the idle set screws... then you want to sync your carbs by adjusting the pull of the slides using the caps. if you use the caps to hold the idle you can run into problems when you turn the bars, if the cable is too tight it will casue the carbs to open more and rev the motor... Quote Link to comment Share on other sites More sharing options...
GHSTRYDAR Posted October 1, 2007 Report Share Posted October 1, 2007 you want to set your idle off the idle set screws... then you want to sync your carbs by adjusting the pull of the slides using the caps. if you use the caps to hold the idle you can run into problems when you turn the bars, if the cable is too tight it will casue the carbs to open more and rev the motor... Can some one send a photo of which whole to drill out for the Idle set screww. I have the cabs aprt and clean I have a piec of wood for insid the carbarrel and I have the drill press set up. Where do I drill :ninja: Thanks jim Quote Link to comment Share on other sites More sharing options...
gumby6t9 Posted October 1, 2007 Report Share Posted October 1, 2007 http://www.bansheehq.com/forums/index.php?showtopic=84021 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.