Tors removal

[stevo3176]

I just took the tors off my banshee and i replaced the caps with aftermarket ones. The ones I got came be adjusted with a screw on the caps which pulls the slides up and down. Can I use this to keep the bashee idleing or do I have to get the idle kit. The ways I have it now it idles fine but I am wondering if I will have problems in the future.

[stevo3176]

And what is roost over by my avatar?

 

 

<----------

[theshee]

So you didnt get the drill and tap with the TORS kit you got?

 

The roost you were asking about are points you get in the casino. :thumbsup:

[stevo3176]

No the kit just came with the caps. I do have a vito idle kit but it does nothave any instructions. Plus is works good now I don't want to fiddle around uless I have too. i was just wondering if anyone else opted not to use an idle kits and just used the adjustments on the caps.

[Bansh-eman]

you want to set your idle off the idle set screws... then you want to sync your carbs by adjusting the pull of the slides using the caps. if you use the caps to hold the idle you can run into problems when you turn the bars, if the cable is too tight it will casue the carbs to open more and rev the motor...

[GHSTRYDAR]

you want to set your idle off the idle set screws... then you want to sync your carbs by adjusting the pull of the slides using the caps. if you use the caps to hold the idle you can run into problems when you turn the bars, if the cable is too tight it will casue the carbs to open more and rev the motor...

Can some one send a photo of which whole to drill out for the Idle set screww.

I have the cabs aprt and clean I have a piec of wood for insid the carbarrel and I have the drill press set up.

 

Where do I drill :ninja:

Thanks

jim

[gumby6t9]

http://www.bansheehq.com/forums/index.php?showtopic=84021