cutting stock fenders

[BSHEE400]

can anyone show me some good close up pictures of cut front fenders so that i can see where i should cut the floppy, dis-colored bastards (when i have a crash it's normally a pretty big one) thanks

[Ricehater]

When i cut mine i used masking tape to get the design i liked.... just go slow and cut off a little at a time untill they start looking cool ... i used a jig saw with a plywood blade and it cut them very good but make sure you use alot of masking tape so you dont scratch the fenders with the saw .... i put tape on the bottom of the saw and on each side of the cut leaving about 1/8th inch in between as a guide..... then i used 200 grit sandpaper and wet sanded the edges

 

 

 

 

 

 

 

 

 

I dont know if this helps ...kinda dark... maybe you can brighten up your screen

Edited September 24, 2007 by Ricehater

[Animalman294]

I did mine with a 4" angle grinder with a cut-off wheel, and it turned out really clean after cleaning it up with a little sand paper...............

[Dinner]

I taped mine off, then took a marker so i could follow along easier, then took a utility knife and cut away. Took me a little while being as I took little amounts off at a time, but they turned out good. I did the simple "race cut" fenders..so it wasn't too hard.

 

Taken today:

Taken tonight:

Edited September 24, 2007 by Dinner