IROOST1 Posted December 20, 2006 Report Posted December 20, 2006 Im gettin a bog just off idle, it doesnt die. It just lopes then takes off. Only when riding it too. Im at 280 mains, 1.5 out air screw, ? pilots, third clip stock needle. 1999 Yamaha Banshee w/ title 2001 Motor Bills pipes and silencers(repacked) Stock Carbs with tor removal kit Cylinders bored, honed and chamfered by Eric Gorr(.020 over) Wiseco Prolite Pistons New welded crank Pro flow aluminum airbox adapter with K/N filter Aluminum Boost bottle w/ brand new manifolds AIRBOX LID OFF ILLINOIS, its cold out ANY SUGGESTIONS??? Quote
dajogejr Posted December 20, 2006 Report Posted December 20, 2006 You really need to know the pilot size. I'd bet they are stockers (25)..and they should be ok. Try turning the air screws in all the way, back them out .5 turns each. Then....wait 20 seconds for the adjustment to take effect, go for a ride. (make sure the bike is fully warmed up) Since it's getting cold out my mid-west brother, might be time to bump up the main a size or two. If your bike runs best with less than 1 turn out on the airscrew, you need a bigger pilot. With your mods, though...I think stock pilot will be fine. Quote
bansheeseat$$ Posted December 20, 2006 Report Posted December 20, 2006 I second that on the pilots.Also you may want to try a 1.8 air jets in those stock carbs(1.6 is stock).It will richen up mid and top a little. Quote
phxrider Posted December 27, 2006 Report Posted December 27, 2006 Dropping my pilot from 30 to 27.5 and raising my needle to the fourth clip (Toomey Needle) cleaned my bottom up real good. Mine would sputter a little and hesitate. Quote
23champ Posted December 27, 2006 Report Posted December 27, 2006 just raise the needle one or two clips Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.