banshee350twin Posted March 5, 2006 Report Posted March 5, 2006 Hi well i got everything figurd out i plane on haveing a vitos big bore kit installed have it fully ported and with a 4mm stroker and 36 mm carbs what do u all think. Twin Quote
blueshee03 Posted March 5, 2006 Report Posted March 5, 2006 sounds good.who's doing the installation and porting? Quote
banshee350twin Posted March 5, 2006 Author Report Posted March 5, 2006 www.bansheesuperstore.com Quote
banshee350twin Posted March 5, 2006 Author Report Posted March 5, 2006 what do u think it would be pushing out for horse power. TWIN Quote
broke Posted March 5, 2006 Report Posted March 5, 2006 I think after all these posts to scrap the Vito's parts, give a builder a call and get set up with a 4mil cub and be satisfied with 90+hp. If I didn't trail ride so often, that would be my move right now. Quote
banshee350twin Posted March 5, 2006 Author Report Posted March 5, 2006 Yea i no cheetah is the way to go ill have a cheetah set up in a few years this banshee got be all done up stripping it down painting the frame mirrior white with whit full bore plastic and im just soupin up the engine a little bit to go with the great looking banshee im gonna make.TWIN Quote
lowriderb Posted March 5, 2006 Report Posted March 5, 2006 for the cost of the sleeves being put in and all you could just buy a set of cub cylinders.. un-ported they will make more power than a big bore stock cylinder set up.. matter of fact a set of stock bore cylinders would make more power than the big bore sleeves in a stock cylidner because of how much it cuts down on the transfer area on the already small transfers.. Quote
banshee350twin Posted March 5, 2006 Author Report Posted March 5, 2006 thanks for the advice but ive changed my mind im gonna go with a honda 250r Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.