Speedie Posted January 5, 2006 Report Posted January 5, 2006 My bike is down, so I figure I put on a set of Fullbores I have. I have a problem with the radiator cap not being in the right location, too far back Do I have to relocate the radiator? I already removed the bracket for the factory radiator cover next to the handle bars. I could tell that it was in the way. If I need to relocate the radiator, can I just use washers and move the top forward the distance I need? Quote
ellison445 Posted January 6, 2006 Report Posted January 6, 2006 You have to remove the bracket that holds the cables and it will fit fine. Quote
Bansh88 Posted January 6, 2006 Report Posted January 6, 2006 yep. Its a bitch to take off without removing radiator. 2 small bolts Quote
89Steeda Posted January 6, 2006 Report Posted January 6, 2006 I used the washers. The real problem is when the bike gets gets flipped and lands on the bars. It bends the frame. Thats the real reason why the radiator is back further than it should be. Quote
Speedie Posted January 6, 2006 Author Report Posted January 6, 2006 I used the washers. The real problem is when the bike gets gets flipped and lands on the bars. It bends the frame. Thats the real reason why the radiator is back further than it should be. 455878[/snapback] That makes sense it has been rolled hard. It has a bend sub frame and headlight mount. It would make sense the frames is bent there too. I have have plans for a new black frame in a few weeks. I'll just wait till I get that before I put the fullbores on. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.