REALLY NEED SOME INFO

[Handyman]

oK people now that I have the enf=gine break in almost done I have found a new problem at higher speeds. It seems like when I'm in 3rd, 4th gear my left cylinder seems to cut put and when I romp on it it fires fine and I have to hold on for dear life so I won't get left behind. I switch plug wires from one side to the the other and it seemed to not be as bad. It almost felt like they both cut a little...and it also seemed like the problem changd sides. Any help is really needed so I can finish the engine break in process.

[stclark816]

Id check for a clogged jet or possibly an air leak. Could very well be electrical as well. Just some suggestions..

[Handyman]

I doubt it's an air leak since it moved to both sides after I swapped the spark plug wires....

[Dead Op]

Sounds electrical man

[Handyman]

Sounds electrical man

400333[/snapback]

 

Yeah I think the same thing....Looking for a coil but can't find any online....KNow fo any websites here I can get one.

[switchblade]

You need to pull your boots off your coils and clean them them crimp them down a little. when coils fail they quit all together. I bet you just need a better conection to your plugs.

[Handyman]

You need to pull your boots off your coils and clean them them crimp them down a little.  when coils fail they quit all together.  I bet you just need a better conection to your plugs.

400340[/snapback]

 

Will try that..What else is part of the system that causes spark??

[switchblade]

If you pulled your motor out for the topend. I would check and make sure all the wires form the stator are tight and all the ground wires are clean and tight agenst metal.

[endofitall9]

I had the same problem. I will say its electrical also. check you wiring harness, thats where i found my problem to be, also i would test your coil and pickup