Pro Design Kill Switch

[BrianEb]

I'll try to make this quick:

I installed the new kill switch according to the directions on the

BlueTraxx.com web site. Everything went together smoothly, when I started the shee up and pulled on the tether cord it killed the motor just like it was susposed to.

 

The problem happen later when I was out riding and showing it to my buddies and pulled on the tehter cord It did not kill the motor, The motor just kept running.

at least it worked once.

 

Does anyone know what the problem could be?

[superchicken]

did ya check the wires to make sure they didnt come apart?did ya solder the conections or use those crimp conections or just the old twist one up and tape it procedure?

[FIRST BANSHEE]

check your ground, make sure it has a good connection.

check your wiring.

make sure the plunger on the kill switch is moving in when the teather is pulled.

[RNBRAD]

You may have bought the "use them once throw them away" kill switches. J/K ditto suggestions above.

[BrianEb]

I did solder them together and tape them up with electrical tape.

If the wires came apart I don't believe I would be able to start it.

I will have to check my ground wire.

 

What do you mean to make sure the plunger is moving on the kill switch.

 

Thanks you two for all your help

[fixitrod]

Test the switch with an ohm meter to make sure it's working properly.

[BrianEb]

The Plunger that was the problem it was not moving in

Now it works!!! I'm happy boy now!

 

Thanks you FIRST BANSHEE dude!