Mod Banshee Posted August 23, 2004 Report Posted August 23, 2004 We ported My shee with Race Logic Porting Templates but we did not do the Transfer windows. Do you think I should get them Done? The specs for this is 43mm from the Top of the Cylinder to the Top of all 5 Transfer port windows. Quote
Oilsmoke Posted August 24, 2004 Report Posted August 24, 2004 Where did you get that spec? I am just curious. Quote
Mod Banshee Posted August 24, 2004 Author Report Posted August 24, 2004 That is the spec from Race Logic Quote
snowprophet1 Posted August 24, 2004 Report Posted August 24, 2004 If you have the 90 degree porting tool, do it. It helps for sure. Quote
Mod Banshee Posted August 24, 2004 Author Report Posted August 24, 2004 (edited) No I dont have a 90 degree porting tool. But does any one know were I can buy on. Edited August 24, 2004 by Mod Banshee Quote
snowprophet1 Posted August 24, 2004 Report Posted August 24, 2004 C.C. Specialties has them, but it's part of a porting set, and the 90* piece is not cheap, and although you can buy just the 90* piece, you have to have the motor, shaft, footpedal etc to use it. Quote
fixitrod Posted August 24, 2004 Report Posted August 24, 2004 I've heard that the transfer windows can be where a majority of the power gain comes from. You have to get fuel in before it can go out. Does dremel make some kind of 90* tool. Quote
DamageInc. Posted August 26, 2004 Report Posted August 26, 2004 yes they do make a 90' but if i remember correct its to big for the banshee cylinders Quote
fixitrod Posted August 26, 2004 Report Posted August 26, 2004 This is about all I could find for the dremel http://www.dremel.com/html/home_fr.html Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.