duketj8 Posted May 12, 2004 Report Posted May 12, 2004 My sleeve was cracked on my left cylinder so I took both cylinders to be worked on, one resleeved and one bored out. When I picked them up the wrong cylinder was resleeved and the sleeve was not in straight. So the guy is going to resleeve both of the cylinders again. What should I look for to make sure this idiot did it right this time? Do the new sleeve port holes need to be the ground to the exact same size as the holes in the cylinder? Thanks, Greg Quote
hamuel Posted May 12, 2004 Report Posted May 12, 2004 take them and Run? after asking for the cash to get them fixed else were and your money back? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.