Key Switch Shortening

["thenewguy"]

i dont have the key to my key switch, i want to take it off but i found that it wont start if its not on there. i was wondering if i could shorten it and crimp the wires back together? will this mess upo the timeing with something or is it not a problem? i just dont wanna blow a piston doing something like this. thanks

[99screaminshee]

the keyswitch has nuthin to do with the timeing

take the 4 wires and twist them all together then tape it up sumwhere

[sredish]

the keyswitch has nuthin to do with the timeing

take the 4 wires and twist them all together then tape it up sumwhere

hotwiring mothaf*&ka

 

yeah, just take the wires and put them together and that will get it to go, better yet, get you a tether switch and put that on there.

["thenewguy"]

what puzzles me is that it starts even thought the wires are not crossed. it must be hot wired some where but i dont know where? i dont know if the key switch it turned on or not. could some one tell me where the key placement is? like on the switch there is a litle black plastic tab like it fits into a mount or something, should it be turned to the left or right? with the fat end of the key switch near that plastic tab? if you have no idea what im talkin about thats fine. i just dont know why its starting? lol, im not complaining just doesnt make sence. lol

[Nighty]

On my old blaster the keyswitch Broke the contact.

so basicly with the key in the ON position it removed contact to ground or something

with the key in the OFF position it made contact to ground causing blaster to not start..

I once forgot my key on a day out riding,

i disconnected the keyswitch and could ride without my key.

 

this might also be the case for the banshee?

See what happens when you twist em together.