AngleOfDeath Posted February 5, 2004 Report Posted February 5, 2004 is it allright to use automotive plug wires. I was wanting to use a different color of plug wire Quote
banshee04le Posted February 5, 2004 Report Posted February 5, 2004 I believe the wires are an integrated part of the ignition coil, which would make it very difficult to change. Other than that, it would work fine. By the way, what is the angle of death...about 66.6 degrees? Is it acute or obtuse? Did you mean angel of death? Quote
evil Posted February 6, 2004 Report Posted February 6, 2004 By the way, what is the angle of death...about 66.6 degrees?Is it acute or obtuse? Did you mean angel of death? dut duuut dut (drumroll funny !) no automotive plugs wont work, i called jacobs electronics and they can make a set, just need the plug that goes into the coil, and its not cheap !!! Quote
boonman Posted February 6, 2004 Report Posted February 6, 2004 I beg to differ with y'all on this. because I have done this myself. I used Taylor wires on my bike and it worked fine. Only thing that caused a problem, is that you have to remember to use "R" type spark plugs. The stock banshee caps are loaded. WHich means that there is a resistor built in to the cap to decrease interference that may be fed back to the CDI. You have to remove the plastic clip that is on the coil, which pinches the wires and holds them in place and then unscrew the wires. Then, simply thread the new wires in there. I did this on my original coil and eventually ended up snapping one of the studs. If you have an older coil, I wouldn't recommend doing this. You may end up doing the same.... Quote
H300F Posted February 6, 2004 Report Posted February 6, 2004 I used the same wires that my dad has on his SBchevy. Work fine. I snapped that holder so I just siliconed them in and put zip ties around. Quote
illboogie Posted February 6, 2004 Report Posted February 6, 2004 i think MSD sells a coil for the banshee that you can change the wires on Quote
geaux 4 it Posted February 7, 2004 Report Posted February 7, 2004 Use the TAYLOR PRO wires.Yhey have a steel core instead of the carbon and they will at last the carbon wires. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.