GA1998 Posted January 8, 2020 Report Posted January 8, 2020 So I just got my 96 banshee last week, never had one before and I'm no mechanic.. it ran fine this whole time until today, I just put a full tank of fuel into it pulled it out of the garage and started it. Started like it usually does after a couple kicks. Then it backfired and slowly died.. I started it a couple more times but it wouldnt idle and now I cant get it to start unless I let it sit for a while.. any ideas? Quote
375hp banshees Posted January 8, 2020 Report Posted January 8, 2020 Try taking fuel cap off & see if it helps Sent from my SM-A505U using Tapatalk Quote
GA1998 Posted January 8, 2020 Author Report Posted January 8, 2020 Will that usually make it quit? Because I filled it to the brim.. lol Quote
375hp banshees Posted January 8, 2020 Report Posted January 8, 2020 Possibly, if it can't vent or doesn't vent and you just filled it so ... now you say filled it to the brim . I would start There and it's easy too Are your fuel lines clear? Sent from my SM-A505U using Tapatalk Quote
BumbleShee350 Posted January 8, 2020 Report Posted January 8, 2020 You probably sucked some junk up from the bottom of your carb bowls and now your jet circuit is probably clogged some where. Quote
375hp banshees Posted January 8, 2020 Report Posted January 8, 2020 ^ step 3Sent from my SM-A505U using Tapatalk Quote
ginger Posted January 9, 2020 Report Posted January 9, 2020 what oil to gas ratio did you mix the fuel? Quote
GA1998 Posted January 9, 2020 Author Report Posted January 9, 2020 I cleaned the plugs.. I'm going to get some new ones today. And I run 4 oz. Per gallon Quote
GA1998 Posted January 11, 2020 Author Report Posted January 11, 2020 All fuel lines are clear.. how do you remove the slides from the top of the carburetors? I want to check the bowls Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.