4mill short rod bottom end

[Duke 2 Stroke]

I have a 4mill short rod bottom end I just put together and I have a friend of mine that have a set of oem cylinders full drag ported that he took off his 4mill long rod setup. My question is can I use that same top end with my my short rod bottom end 

[trickedcarbine]

1 hour ago, Duke 2 Stroke said:

I have a 4mill short rod bottom end I just put together and I have a friend of mine that have a set of oem cylinders full drag ported that he took off his 4mill long rod setup. My question is can I use that same top end with my my short rod bottom end 

You should be able to put them on and run a normal banshee piston instead of the typical Weisco 795 piston.  I'd suggest getting a few different base gaskets to mock it up and see where it sits the best. 

[BigP19]

Same thing no difference, just the long rod is a safer route due to the rod angle but port timing wise your fine