Primary gear

[jmross]

My primary gear is grooved at the seal fit.  I saw you can order it separate from the clutch basket.  The manual says something about gear mesh and numbers on the gears.  But there is only one part number and no adjustment.  So if the new gear does not have proper back lash.....then what?  If I should buy them together I figure I might as well go with straight cuts for the price.  This is going on a driveline high port 4mm.  

Thanks

Edited September 12, 2017 by jmross

[trickedcarbine]

Buy a matched set

[jmross]

Do i need to run the convex washer behind the cushion plate?

[trickedcarbine]

I do, but I know a lot of fella's who chuck them.