51222 Posted December 2, 2003 Report Posted December 2, 2003 hi i just installed in my shee TT6 pipes, V-force reeds, vito's power head and twin K&N filters and when i started the engine evrything worked normally it was idealing perfectly but when i rided the bike it started backfiring and wasnt giving me acceleration in full throttle position and when the engine was hot and i kick the 1st gear while holding the clutch the engine dies . so plz and help ?? Quote
yama_dog_350 Posted December 2, 2003 Report Posted December 2, 2003 did you change your jeting? Quote
51222 Posted December 2, 2003 Author Report Posted December 2, 2003 yes i did and re-checked it but the same problem Quote
SDD Posted December 2, 2003 Report Posted December 2, 2003 Tighten your parking brake then adjust your idle. After you do that adjust your clutch cable. Quote
txblueshee Posted December 2, 2003 Report Posted December 2, 2003 Did you put your slides in backwards?? Did you adjust the air/fuel screws?? Did you get the carb tops all the way back on?? Did you make sure you didn't bend the needle?? Did you change your pilot jet.... what are your jets?? Mike Quote
Demon350 Posted December 2, 2003 Report Posted December 2, 2003 same problem. i found out the problem was the airscrews. check them out and take them out 1/2 turns each time till u get best throttle, every1 sais the airscrew is for ideling n sht but thats what sorted out my top end, later Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.