Dalton Posted October 7, 2015 Report Posted October 7, 2015 4mill Complete Top End Drag Ported Stock Cylinders, porting done by Alan Cain 66mm Blaster Pistons 19cc Race Gas Domes Compression Tested at 170PSI before pulled Low hours runs hard Bolt on and go No studs for head $450 Shipped Gifted payment or pay fees Quote
Dalton Posted October 7, 2015 Author Report Posted October 7, 2015 I have a correction to make.... the piston size is 66.25 Blaster pistons. I also want to disclose a very micro crack on the left cylinder only see picture No problems running this set up Quote
mike0chek Posted October 7, 2015 Report Posted October 7, 2015 nasty spot for a crack, props for being honest for the sale 1 Quote
Dalton Posted October 8, 2015 Author Report Posted October 8, 2015 nasty spot for a crack, props for being honest for the sale Thanks Quote
BANSHEE HP Posted October 8, 2015 Report Posted October 8, 2015 the crack I see wont affect anything. its just the aluminum casting. the steel sleeve behind it wont be cracked. 2 Quote
n2otoofast4u Posted October 8, 2015 Report Posted October 8, 2015 That crack makes zero difference. Will have no effect. 1 Quote
Dalton Posted October 8, 2015 Author Report Posted October 8, 2015 That crack makes zero difference. Will have no effect. I agree. Just wanted to show it. 1 Quote
Dalton Posted October 8, 2015 Author Report Posted October 8, 2015 the crack I see wont affect anything. its just the aluminum casting. the steel sleeve behind it wont be cracked. I agree. Just wanted to show it. 1 Quote
BANSHEE HP Posted October 8, 2015 Report Posted October 8, 2015 I understand, just wanted to make sure that other people dont get carried away on whether that cylinder is junk Bump for some good looking ported cylinders 1 Quote
Dalton Posted October 8, 2015 Author Report Posted October 8, 2015 I understand, just wanted to make sure that other people dont get carried away on whether that cylinder is junk Bump for some good looking ported cylinders Thanks again for pointing that out. These are excellent cylinders and a lot of work was put into them! 1 Quote
sleeper06 Posted October 10, 2015 Report Posted October 10, 2015 Glws those have a ton of work done, that's a 7-9 Hundo port job Quote
Dalton Posted October 10, 2015 Author Report Posted October 10, 2015 Glws those have a ton of work done, that's a 7-9 Hundo port job Yes a lot of work was done on these cylinders! They run hard! Quote
xbig pitax Posted October 14, 2015 Report Posted October 14, 2015 What base gasket is needed to run these and what are the exhaust and trans timing Quote
Dalton Posted October 14, 2015 Author Report Posted October 14, 2015 What base gasket is needed to run these and what are the exhaust and trans timing Stock base gasket. No spacer plate. Ran with a 4mil crank. I don't know what the timing is. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.