xTHUNDERCATx Posted August 8, 2015 Report Share Posted August 8, 2015 (edited) I have a carrier that was running a single 40mmx62mmx24mm bearing per side. I'm swapping in new bearings but I'm not sure if it would be better to run 2 40mmx 62mmx12mm bearings (The kit JJ&A sells) or getting a set of direct replacements. Any opinions on this one? Edited August 8, 2015 by xTHUNDERCATx Quote Link to comment Share on other sites More sharing options...
Lowflyin Posted August 8, 2015 Report Share Posted August 8, 2015 I like duals Sent from my LG-D850 Quote Link to comment Share on other sites More sharing options...
xTHUNDERCATx Posted August 8, 2015 Author Report Share Posted August 8, 2015 Is there a reliability difference between the set ups or is it about the same either way as long as they aren't crappy bearings? Quote Link to comment Share on other sites More sharing options...
xTHUNDERCATx Posted August 8, 2015 Author Report Share Posted August 8, 2015 (edited) Double post. Edited August 8, 2015 by xTHUNDERCATx Quote Link to comment Share on other sites More sharing options...
Lowflyin Posted August 18, 2015 Report Share Posted August 18, 2015 Sorry don't check back much but my thoughts are, if you have a single bearing locked up on one side it may be Way tougher to get it home rather than 1 out of 2 bearings locked on a single side. If that makes sense. Sent from my LG-D850 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.