brianault22.ba Posted July 3, 2015 Report Posted July 3, 2015 I've cleaned my slides got all the carbon off and have no air leaks, but yet it still wants to rev high Sent from my VS985 4G using Tapatalk Quote
brianault22.ba Posted July 3, 2015 Author Report Posted July 3, 2015 It idled and runs good then out of no where it revs high Sent from my VS985 4G using Tapatalk Quote
brianault22.ba Posted July 3, 2015 Author Report Posted July 3, 2015 After I rev it. It almost sounds like its sticking Sent from my VS985 4G using Tapatalk Quote
dankengineering Posted July 3, 2015 Report Posted July 3, 2015 Sounds like you have the slides in the wrong carbs sent from somewhere Quote
brianault22.ba Posted July 3, 2015 Author Report Posted July 3, 2015 I don't think so Sent from my VS985 4G using Tapatalk Quote
trickedcarbine Posted July 3, 2015 Report Posted July 3, 2015 Cut always should face the back, pull the filters to see if it is actually sticking or not. Could be tha cable or throttle if it is. If it isn't sticking, you probably have an air leak. The later of the two is a good recipe for a melt down. 1 Quote
brianault22.ba Posted July 3, 2015 Author Report Posted July 3, 2015 Cuts are toward back I'm if its sticking when I get home I'll check and let's pray its not a air leak Sent from my VS985 4G using Tapatalk Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.