banshee jump Posted November 9, 2014 Report Posted November 9, 2014 Hello I need you're help troubleshooting so when i start my banshee and in neutral and engage the clutch and press on a gear the bike just moves forward a bit.what could be the problem bad clutch basket?gears are hard to shift and its hard to find neutral.Thanks Sent from my iPhone using Tapatalk Quote
Soskunked Posted November 9, 2014 Report Posted November 9, 2014 Check your clutch cable see if it needs adjusting.. Quote
Larry's Shee Posted November 10, 2014 Report Posted November 10, 2014 It does it wether hot or cold? While warming up try pulling/release clutch several times (plates sticking) Or you just have a grooved basket Quote
trickedcarbine Posted November 10, 2014 Report Posted November 10, 2014 What's the age of all the clutch components. Might even be time to replace and adjust a couple things. Check the basket and hub for grooving. Adjust the eccentric bolt Check cable and adjust Check adjuster at pressure plate Quote
banshee jump Posted November 10, 2014 Author Report Posted November 10, 2014 What's the age of all the clutch components. Might even be time to replace and adjust a couple things. Check the basket and hub for grooving. Adjust the eccentric bolt Check cable and adjust Check adjuster at pressure plate . It does it while warming up alot and after it has warm up little bit as for clutch i have never changed it in 5 year of usage never adjusted clutch cable aswell Sent from my iPhone using Tapatalk Quote
banshee jump Posted November 10, 2014 Author Report Posted November 10, 2014 Check your clutch cable see if it needs adjusting.. no i dont think its clutch cable as there is no feeling of the clutch being pulled but my discs are very old they must be the problem Sent from my iPhone using Tapatalk Quote
camp0429 Posted November 10, 2014 Report Posted November 10, 2014 Mine was doing the same thing after being put back together after a rebuild a couple months ago, was fine before. I had the actuator lever aligned with the case arrow and no matter how the cable was adjusted it always jumped when I put it in gear. I finally adjusted the pressure plate to where the actuator is to the left of the case mark, also adjusted the eccentric bolt, and adjusted cable. Its fine now 1 Quote
Soskunked Posted November 10, 2014 Report Posted November 10, 2014 Adjuster at pressure plate .. Quote
banshee jump Posted November 11, 2014 Author Report Posted November 11, 2014 Adjuster at pressure plate .. dont you think its the outer and inner hub? Sent from my iPhone using Tapatalk Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.