Carbs

[sprinklerman]

Thank ya sir!

I edited my post.

[banshee35027]

What's better airstykers or pj?

[trickedcarbine]

PJ

[camatv]

pj's suck compared to pwk OR pwm's..  

 

i would rather run stock than pj's

 

the slide cut out and plating has to be matched if your missing one carb.  the slide cut out is in the bottom of the slide.  i believe there are a lot of differnt cutaways.  available  it is actually a big part of the idle, just off idle tuning circuit

[possum]

And there us a flush style and recessed style slide on the very bottom side.

[trickedcarbine]

pj's suck compared to pwk OR pwm's..

 

i would rather run stock than pj's

 

the slide cut out and plating has to be matched if your missing one carb. the slide cut out is in the bottom of the slide. i believe there are a lot of differnt cutaways. available it is actually a big part of the idle, just off idle tuning circuit

Agree, but I'd rather run pj's then the air strykers

[camatv]

why??  i have taken countless pj's off  installed 35mm pwk air stryker and noticed a nice gain in the off pipe performance in the lower end.. ?  plus the idle and adjust off a screw instead of the choke bypass

[trickedcarbine]

Meh, I've just never had some long enough to learn them well I guess. Just always seemed finicky from pilot on to needle on the few sets I've tinkered on. I love the way the idle adjusts on PJ's with the knob. Cant stand the way PWK's and strykers idle and air screw aren't left and right specific even though they were cast for it. But that's just my own thoughts.

[trickedcarbine]

What needles do you like on strykers cam?