Right Cylinder not running

[Burke]

check with the weed whacker mechanic yet?

[ETR174]

check with the weed whacker mechanic yet?

Did you check with your mind about posting this and not your ass?

[Bennett131]

Did you check with your mind about posting this and not your ass?

Good one...

[Larry's Shee]

Start from the begining and check every little thing.

 

 

Do recall seeing something about your jetting  ...................................

[ETR174]

Yeah my jetting is straightened out. I'm thinking intake now because it started doing this before I did the timing plate mod and everything. They were used Boyesen reeds I threw in it.

[Larry's Shee]

When you got done with timing plate, did you set pickup gap? .018, checked at both nubs. Also make sure nubs are clean.

[ETR174]

Yes. I set it with a buissness card I measured at .018 with calipers.

[ETR174]

So did you figure out what was wrong KAMIKAZE?

[trickedcarbine]

It went boom. Other thread.

[ETR174]

I don't see how. It was running fine a week ago. I will do a compression test tomorrow.

[ETR174]

I think its just the plug. Its wet everywhere. Was probably dead when I got it.

[Bennett131]

Well put another one in and try it then lol.

[Burke]

Take your common sense elsewhere

[ETR174]

Just did. Had to go and buy some. Its going more now just seems like its running rich on that cylinder. The right side exhaust got warm but not as much as the left.

[ETR174]

Ok finally got to taking the reeds out and somehow one of the side's screws got stripped out ad the reeds were barely hanging on. Good thing I got to it sooner or I would've been in deep shit!