uman1030 Posted April 8, 2014 Report Share Posted April 8, 2014 This is in regards to the brake conversion. After some research it appears in 2007 they "redesigned" the YFZ 450 front master cylinder to produce more pressure. So obviously 2007+ would be the optimal Front master cylinder to get. I'm curious if the previous year of these front master cylinders still produce more pressure then the stock banshee master cylinder. I have 2x 2006 YFZ 450 master cylinders. I have the calipers installed, lines ran and bled with the original banshee master installed. Bike is still being assembled so i cant really test anything other then i know they work. Since I also have the YZ450 front master cylinders. Will it be of any upgrade to even use one of them? Quote Link to comment Share on other sites More sharing options...
Glenyboy Posted April 8, 2014 Report Share Posted April 8, 2014 Some have said the yfz master cylinder alone is an upgrade over the banshee one. Quote Link to comment Share on other sites More sharing options...
Man-O-Steele Posted April 8, 2014 Report Share Posted April 8, 2014 im running yfz calipers with banshee master and it works just fine. its not mushy or anything.. Quote Link to comment Share on other sites More sharing options...
stink989 Posted April 9, 2014 Report Share Posted April 9, 2014 I ran the 450 calipers with the banshee master for a while. Then upgraded to a master off a 2010 yfz450r (not sure of the same as the older models) and it was a big upgrade again. Sent from my iPhone using Tapatalk Quote Link to comment Share on other sites More sharing options...
WINDYCITYJOHN400 Posted April 9, 2014 Report Share Posted April 9, 2014 Does the banshee brake lever work on the YFZ master? (I have ASV Banshee levers) Quote Link to comment Share on other sites More sharing options...
sheerider11 Posted April 9, 2014 Report Share Posted April 9, 2014 Does the banshee brake lever work on the YFZ master? (I have ASV Banshee levers)I was told no. That's the only thing keeping me from doing it. But you can send it to asv if you want and they can change the part that pushes the master Quote Link to comment Share on other sites More sharing options...
Coupelx Posted April 9, 2014 Report Share Posted April 9, 2014 Most of you are missing his question. my thoughts are to disassemble both and measure the bore. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.