Ebrake Block Off

[DRACUTRIDER]

hey. i just got rid of the ebrake set up on my bros banshee and now it wont rev. i know its becasue of the button so how do i fix it? do i cut the wires goin to it and splice them together? please help

[Blacksmith]

Simply remove the switch from the clutch lever assy, and then unplug it from the wiring harness. This will fix your problem

[Leadfoot350]

Also take off the little black box under the gas tank on the left side of the bike. Thats about it.

[SICK BOY]

I never took the black box off,does it need to be?What does it do?

[Bigairee]

I believe you should not have connected the 2 wires you cut. Here is a wiring diagram of the circuit.

[boonman]

If you unplug the black box under the tank, which is adjacent to the ignition coil. This will completely disable the TORS system.

[Justintoxicated]

I left my tors in tackt. SDD put a new clutch lever on my shee which removed the parking break lever, cable and the parking beak near the brake disc was replaced with a parking break block off (nice shiny billet one)

 

Total cost was about $50...I still have my TORS in tact untill I change carbs, I have never had a problem with it OTHER than with the parking brake part of it.

[Blacksmith]

While I hate to disagree with what anyone posts, I have to say that I don't think you really want to connect the two wires that run to the parking brake lever. If you use a meter you will see that this circut is open when the lever is not pulled back. Closing the circut will make the bike think that the lever has been pulled.

[Leadfoot350]

dont connect anything just remove the black box. Less weight too!!!!!!!