Chuckie02Shee Posted September 12, 2013 Report Posted September 12, 2013 While putting my Shee engine back together I noticed that the RH side crank bearing pin is much shorter than the LH side is this normal? I was thinking that it was to denote LH from RH,but doesn't make sense. Both sides in the case to capture the crank bearings are the same size. All feedback is welcome and appreciated!! Thanks in advance Quote
BANSHEE HP Posted September 12, 2013 Report Posted September 12, 2013 tap on the longer one and see if it doesn't slide in a bit further. Quote
Chuckie02Shee Posted September 12, 2013 Author Report Posted September 12, 2013 That's the problem,the longer one actually fits as it should by looking at it. the short one is so short that it almost isn't captured in the case. the bear hasn't spun around and clipped itself either... Quote
sleeper06 Posted September 12, 2013 Report Posted September 12, 2013 Normal dont worry its like a little nub Quote
Chuckie02Shee Posted September 13, 2013 Author Report Posted September 13, 2013 Thanks sleeper06 that's exactly what it looks like. Going to go ahead and put her together!!! Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.