EZ2FLEE Posted June 16, 2013 Report Posted June 16, 2013 when u guys get your custom paint jobs and your fancy powdercoat, what precautions do you take when putting your engine back in the frame so u dont fuck shit up...an ding here an there... what ive done is lay 1/8 strips of old rubber floor mat on the frame rails and tape one up above just because so if i do happen to slip or have to set it down real quick to get a new grip on the engine i wont fuck shit up anyways just wondering what you guys do in this case...... Quote
dirtydownunder Posted June 16, 2013 Report Posted June 16, 2013 just lay some wiring tape down, or wrap in newspaper and tape up. use a jack, to support the engine to bolt up. dont be a clumbsy fuck and you should be ok. Quote
rubberneck Posted June 16, 2013 Report Posted June 16, 2013 What i like to do with any freshly painted surface is just throw a wrench at it and get the first chip out of the way so i can get on with putting the thing together. Other wise i will waste a shit ton of time being careful throughout the entire assembly process only to nick it the fuck up getting it off the lift or loading it in the truck or putting the very last piece on. Quote
sheerider11 Posted June 16, 2013 Report Posted June 16, 2013 What i like to do with any freshly painted surface is just throw a wrench at it and get the first chip out of the way so i can get on with putting the thing together. Other wise i will waste a shit ton of time being careful throughout the entire assembly process only to nick it the fuck up getting it off the lift or loading it in the truck or putting the very last piece on. never thought of it that way. Probably the best way to go about it Quote
Deadbeat Posted June 16, 2013 Report Posted June 16, 2013 What i like to do with any freshly painted surface is just throw a wrench at it and get the first chip out of the way so i can get on with putting the thing together. Other wise i will waste a shit ton of time being careful throughout the entire assembly process only to nick it the fuck up getting it off the lift or loading it in the truck or putting the very last piece on. LMFAO Quote
FullThrottle_06' Posted June 16, 2013 Report Posted June 16, 2013 I'm tanned and jacked so I don't worry about lifting the motor in and out. No but serisously, when my shit came back from powder, the only thing I did was put down a couple old bath towels to keep from hitting anything. Wasn't that big of a deal Quote
EZ2FLEE Posted June 16, 2013 Author Report Posted June 16, 2013 im no slouch myself but not everyone 6'3" 215lbs haha...i just know that when u trying to keep shit nice is when bad shit happens most likely Quote
Finch Posted June 16, 2013 Report Posted June 16, 2013 some rags but this last time i tried the put a sratch in it first and it went so much easier! Quote
Nightmare Posted June 16, 2013 Report Posted June 16, 2013 Fuck all that fancy dancey shit. Rattle can FTW, easy touch up's:D<br /><br />Sent from my SGH-T679 using Tapatalk 2<br /><br /> Quote
Nieskes Posted June 16, 2013 Report Posted June 16, 2013 I lay my cock across the framethats not funny. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.