camatv Posted October 22, 2003 Report Posted October 22, 2003 i need drag port spec's for sand drag engine(400 stroker) also degree spec's and good triple port spec's for big bore mono block that i have. i want to check this cylinder and see why it sucks? it is a triple port exhaust now but is slow 50-55 horse out of a 68mm 12 port design?? that sucks!!! it has to have a port timing problem ct says it should run 85 horse but they are full of it and they don't really want to help me no more ahhhhhhh Quote
Pasi S. Posted April 3, 2015 Report Posted April 3, 2015 CT sucks!Call to a good site sponsor and let them help you!Dremel hack-port-job is good for nothing, so don´t do it yourself. 1 Quote
#1JUANstunna Posted April 3, 2015 Report Posted April 3, 2015 CT sucks! Call to a good site sponsor and let them help you! Dremel hack-port-job is good for nothing, so don´t do it yourself. Damn it Pasi you thread miner! You are about 12 years too late. lol Quote
m671054 Posted April 4, 2015 Report Posted April 4, 2015 Wonder what that motor turned into. Care to post specs camatv? Quote
RadarRacing Posted April 4, 2015 Report Posted April 4, 2015 Jeez Pasi, what the heck is wrong with you? Lmao. 1 Quote
Dmx Posted April 4, 2015 Report Posted April 4, 2015 Pasi had few+couple beers, just another day at the office 1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.