ZachBreck Posted January 7, 2013 Report Posted January 7, 2013 OK, so earlier in the year I had decent accident, halved a rim and bit a tree pretty tree pretty hard, bent a-arm, bumper, and that was about it. However, my kill switch does nothing now? I can still turn off the shee with the key but the kill switch is useless. Any ideas where to start the trouble shooting? Any suggestions would be great! Quote
So Cal Suspension Posted January 7, 2013 Report Posted January 7, 2013 My guess would be one of the wires going to the switch got broken in the wreck. Does your light, turn signal and horn switch still work? I'd start checking for a broken wire somewhere, and check for continuity. Quote
Finch Posted January 7, 2013 Report Posted January 7, 2013 fallow all the wires make sure there not broke would be my first suggest Quote
ZachBreck Posted January 7, 2013 Author Report Posted January 7, 2013 Yea I ran down the wiring harness and it seems everything is good. Lights still work too. Quote
So Cal Suspension Posted January 7, 2013 Report Posted January 7, 2013 Did you check for continuity at the switch and at the CDI. Quote
Starwriter Posted January 8, 2013 Report Posted January 8, 2013 Wire could have broke off the contact block inside of the switch where they're soldered on or the contact block could have jumped out of place inside the switch. Like Matt mentioned, get out your multimeter and check the switch for continuity. Quote
yzrmbsg Posted January 8, 2013 Report Posted January 8, 2013 Here is a stock wiring harness schematic. Hopefully it will help you out! Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.