port work

[007banshee]

I have a set of cylinders that are around 64.75-64.90 when i send them in to get bored/honed id like to get some porting done. Now if I warm the bike up, leakdown, get jetting spot on and break it in properly that bore should last a long time if it doesnt burn down. With that being said later on down the road if i happen to run out of bores can it be resleeved and the porting be matched?

[thomas h.]

Yup

[troyzstang]

I have read that port work is kind of hard to match up when installing sleeves.

Personally I would try to start with virgin cylinders if you're going to spend the money on port work.

 

Just my opinion

 

Troy

[Finch]

youll be fine the stock cyls i used to have were goin on 10 years take care of them and theyll last you a long time

[thomas h.]

Under 65 mm is pretty good I would port them

[trickedcarbine]

You could always nicasil the sleeves and they will last a long time!