1CrazyBastard Posted September 4, 2012 Report Posted September 4, 2012 Can somebody tell me if this is the proper way/ place to measure on the inside edge of the carb where the bowl contacts to set / measure the Float level I found this pic after some searching but wanna confirm that its correct and 21mm is the correct spec ?? Quote
Starwriter Posted September 4, 2012 Report Posted September 4, 2012 Yes, thats the correct place to measure, but you need to hold it sideways so that it doesn't compress the spring loaded needle. Tip it sideways with the float pivot pin at the top. Tilt the carb till the float just bumps against the needle. Not sure on spec. Don't have my Clymer here with me. Quote
hoppedupandcutdown Posted September 5, 2012 Report Posted September 5, 2012 21mm without the gasket. Quote
1CrazyBastard Posted September 6, 2012 Author Report Posted September 6, 2012 21mm without the gasket. Yeah kinda figured as the gasket is a few mm itself and yes my floats were off a few mm as I wasnt sure about the spring loaded needles and compressing them or not i have got it running pretty good and the floats are at 21mm now Thanks !! Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.