11AGUY Posted April 9, 2012 Report Share Posted April 9, 2012 just finished the total rebuild to include carb rebuilds from Moose racing.... got this beast dialed in with jetting and now, for some reason, I am getting some fuel drips out of the drain tubes that extend from the bottom of the carbs to under the swing arm... Now I had the fuel issue when the floats got stock and came pouring out of the overflow tubes, but not the drain tubes... now were talking about a small amount of fuel coming out of these tubes and not pouring, more or less a few drops the floats are spot and the drain screws are tight as all hell.... what ya think?? Quote Link to comment Share on other sites More sharing options...
Larry's Shee Posted April 9, 2012 Report Share Posted April 9, 2012 did you replace O-rings on ouside of float needle valve seat? Quote Link to comment Share on other sites More sharing options...
Jereme6655 Posted April 9, 2012 Report Share Posted April 9, 2012 Your not supposed to tighten the shit out of them......theyre supposed to be just snug..... When you cranked the Shit out of them you may have put a mark in the tapered end of the drain screw causing it to leak ever so slightly Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.