PE-1's

[DwnSouth]

I need some needles! No marking on mine think I'm gonna just scrap em... Anybody know how to ID them?

[Larry's Shee]

get a magnifying glass and look closer, no shit

[DwnSouth]

get a magnifying glass and look closer, no shit

 

 

COme on na Larry?

[Coupelx]

if you have the patience you can measure the diameter/taper/length and figure out what they are.

[DwnSouth]

Where might this invisible mark be? Do I need to remove it from the slide?

[Larry's Shee]

ya , just below clip grooves, not easy to see, harder to read.

[DwnSouth]

ya , just below clip grooves, not easy to see, harder to read.

 

 

New to lectrons, do they come out the top like a keihin? Remove throttle cable then shakem out the top?

[BigRed350x]

1. lay carb on floor

2. find large sledge hammer

3. smash carbs

4. dig needle out of pile of carb

5. identify needle

6. glue carb back together.

 

 

 

been doing it like this for years. hasn't failed me yet.

[Coupelx]

1. lay carb on floor

2. find large sledge hammer

3. smash carbs

4. dig needle out of pile of carb

5. identify needle

6. glue carb back together.

 

 

 

been doing it like this for years. hasn't failed me yet.

[sheefreak]

The PE1's are very distinct looking. They are hand ground, and are cut to look almost like a V. A lot different than the manufactured metering rods.

[DwnSouth]

The PE1's are very distinct looking. They are hand ground, and are cut to look almost like a V. A lot different than the manufactured metering rods.

PE1's?

[DwnSouth]

PE1's?

 

 

Anybody?

[mailman]

Anybody?

 

They look like PE1's.