Jetting 33MM PWK Carbs (Need Some Assistance)

[Infamous039]

I have a set of 33MM PWK carbs and would like to get a starting point for jetting. You guys have helped me much in the past and I am pretty good at jetting my bike, but just want to get a baseline of where I should begin. Mods listed below.

 

Jets I currently have: Mains 150,152,155,158,160,162,165

Pilots 48,50,52,55

 

Elevation: Sea Level

 

Temperature : 75-65

 

Motor Mods:

Dune Port

33MM PWK Carbs w/ CGL Needles

Pod Filters

21CC Domes

VForce 2 Reeds

+4 Timing

T5 pipes

Stock Stroke Crank

93 Pump Fuel

[Badbar88]

I have a pretty similer set up and I run 160's and 48's if I remember correctly.

[locogato11283]

162 main. 48 pilot. Needle in the middle. Air screws 2 turns out.

[Infamous039]

OK guys I will start with 160 mains. I currently have 50 pilots in and its starting first kick everytime.

[252wheelieking]

I have the same setup with 34 PJ's & mines dailed in with 52 pilots CEG needle mid clip 158 mains. Im in NC at sea level same temps as you.

[locogato11283]

I have the same setup with 34 PJ's & mines dailed in with 52 pilots CEG needle mid clip 158 mains. Im in NC at sea level same temps as you.

The PJ jetting circuit is not the same as the PWK. They can't be cross referenced like you can between the PWK.

[Infamous039]

I am going to see how it runs with the 50 pilots first cause its starting up first kick, I will be able to test it out tomorrow after work and report back.

[locogato11283]

I am going to see how it runs with the 50 pilots first cause its starting up first kick, I will be able to test it out tomorrow after work and report back.

Do you have to choke it? If not, your pilot is too rich.

[Infamous039]

Yes I had to choke for the initial start up and I let run for about 5min or so then shut it down. Every start up after that was just one kick start.

 

Do you have to choke it? If not, your pilot is too rich.